This part of the guide serves to help you in a rapid configuration of the VOIP station, in 10 steps.
We advise you to read the whole guide before starting the configuration.
Step 1
If the default IP address is 192.168.1.1 it does not conform with your network; click on the network menu and
type in the new IP address in
Network -> Management Interface:
Then set up the default gateway and the static routes in
Network -> Routing Table:
Now click on APPLY.
CAREFUL: at this point you need to close and re-open the browser on the new console address.
Step 2
If you have audio or voice announcements to download from the response trees, now is the time to send
them to the station
and then configure the rest.
Click here for how it’s done.
Step 3
If you have the intention of using response trees for incoming calls, or if you do not have a passing selection,
you need to configure at least one incoming tree to manage the incoming calls
. In this step decide the name
of the tree and save it without going into detail, which comes later.
Click here for how it’s done.
Step 4
Configure the incoming provider
and the PRI/BRI lines
.
Step 5
Configure the general parameters.
Step 6
Step 7
Step 8
Step 9
Step 10
Now configure the actions of the incoming trees
The station is functionable now. This guide is only a starting point to help you get it working.
We advise you to read the whole guide before starting the configuration.
